![]() Still, it is a classic and always a bathroom powerhouse. However, that efficiency comes with the downside that the room isn’t all that special, and it has limited counter space. ![]() There’s an efficiency in plumbing cost, as all the plumbing is on one wall. This is an efficient bathroom, and, it just plain works. These bathroom floor plans are simple, efficient, and basically get the job done with no extra fanfare. Lesson 1: Start with the Basics – Standard, and “The Banjo” Alternate It is around 40 square feet (5’ x 8’) and here are the typical rules of thumb for how it works. This is the good old “three-in-a-row” bathroom we’ve all seen. (If you'd like to learn more about either of these, let us know, we’d be happy to elaborate in a new post!) Rules of Thumb for Bathroom Design Lesson 1: Start with the Basics Also, bathrooms in multifamily buildings (like apartments) are a whole different ballgame due to accessibility rules. Bathrooms with just a toilet and a sink, known as powder rooms, are a different animal altogether, and not covered in this post. We’ll look at bathrooms with a shower (¾ bath), or bathrooms with a tub (full bath), or even combinations of both. Side Note: This post covers the basics for single-family residential bathroom design. So, in the selfless interest of trying to make the bathrooms of America a little better, read on for some standard rules of bathroom design. When planning a bathroom (either when building new or remodeling) there are plenty of rules of thumb to follow for bathroom layout. Weird-shaped rooms angled tubs, toilets, showers and generally, spaces that are just plain awkward - these all seem to be hallmarks of poorly-designed bathrooms. To illustrate the point, see how two designers, an architect, and an ardent DIYer made the most of a master bath in-a bit more or less than-a 100-square-foot space.I’ve been in enough homes over the years to observe that designing and laying out a bathroom is apparently a tough nut to crack for a lot of American production builders. Of course, not everyone wants the classic four-piece configuration, even when there’s room, opting instead to ditch a seldom-used tub in favor of a bigger shower, extra storage, a toilet enclosure, or even a laundry closet. “Whatever the shape, clever design can mitigate layout restrictions.” Consider, too, that this size space can also enable higher-end finishes that could break the bank in a larger bath. “A narrow space can be quite efficient, since most fixtures go along a wall, while a square lends more flexibility,” Maggio says. Not all square footage is considered equal, since design decisions are also dependent on room shape and window and door locations. ![]() Is going bigger that much better? It depends. That means allowing for a 3-foot-square shower, 30 inches of clearance alongside a tub and in front of a commode, and a 60-inch-long vanity. It allows for the classic four pieces-a double-sink vanity, a tub, a separate shower, and a toilet-while meeting the minimum standards for comfort and usability. “A hundred square feet can be a nice sweet spot,” says San Diego designer Corine Maggio. Considering a master-bath overhaul and wondering what it takes to fit in everything you want? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |